Restoring FANUC Beta Drive Parameters

1. Make NC PRM 960.3 (PMN) = 0 (Enables PMM function). 2. Select where parameters are to be saved (to save to memory card on i series controls make PRM 960.2 (MD2) = 0 and PRM 960.1 (MD1) = 1, to save as a part program make PRM 960.1 = 0). 3. Set parameter 8760 to the program number you want the parameters to be stored as. Note 1. 4. Press the SYSTEM button then the RIGHT CHAPTER button until the Power Motion Manager screen is displayed. 5. Press the SYSTEM soft key. 6. Press the PARAM soft key. 7. Press the OPRT soft key. 8. Press the RIGHT CHAPTER button. READ and PUNCH soft keys will be...

read more

Motor 3 pha 6 đầu dây

...

read more

PMC alarms

​600 PMC ALARM: INVALID INSTRUCTIONAn invalid instruction interrupt occurred in the PMC.601PMC ALARM: RAM PARITYA PMC RAM parity error occurred.602PMC ALARM: SERIAL TRANSFERA PMC serial transfer error occurred.603PMC ALARM: WATCHDOGA PMC watchdog timer alarm occurred.604PMC ALARM: ROM PARITYA PMC ROM parity error occurred.605PMC ALARM: OVER STEPThe maximum allowable number of PMC ladder program steps was exceeded.606PMC ALARM: I/O MODULE ASSIGNMENTThe assignment of I/O module signals is incorrect.607PMC ALARM: I/O LINKAn I/O link error occurred. The details are listed below.607 010*...

read more

System alarms

​The 950 PMC SYSTEM ALARM can be caused by a problem with the I/O, particularly if an external voltage is applied to the I/O system. The 911 RAM PARITY ERROR alarm may mean that the Memory board has failed but it may also mean simply that the parameters have been lost due to a bad battery. The only way to find out is to do a memory clear. Turn the NC off, hold the RESET and the DELETE button, turn the NC back on while holding both buttons. If the alarm goes away and is replaced with servo alarms, etc. then the Memory board is probably ok. At this point you must follow the procedures for...

read more

Axis card 3/4 or 5/6

read more

Tuyển dụng

Để phục vụ cho nhu cầu phát triển sắp tới, Savotech tuyển dụng các vị trí sau

02 Kỹ thuật viên Cơ

02 Kỹ thuật viên Điện

01 Kỹ thuật viên Điện tử

Các bạn yêu thích lĩnh vực máy công cụ, các loại máy CNC, muốn tìm tòi nghiên cứu hãy đến với chúng tôi.

Xin liên hệ qua mail: tuanfanuc@gmail.com

Hoặc SMS, Zalo, Viber 0983574244

Powered by WordPress Popup